Peumatic Grouting pump is designed for stress and filling grouting of cement and bentonite slurries. It is primarily used for injecting (grouting) bar anchors and the drill holes in order to reinforce the unfastened rock mass. The most grain dimension cannot exceed 0.2 mm.
Grouting pump operation and upkeep is simple, protected and reliable. This pump is used in mines operating beneath tough circumstances because it’s dependable and explosion-proof.
Basic Pneumatic Grouting pump embody: An air inlet, the pneumatic cylinder, mounting base body and stand, strain gauge, pumping cylinder, outlet with quick launch coupling and wheels.
How it actually works
Pneumatic stress in the air cylinder exerts a excessive stress on the grout combination which ends up in ejection of grout with a excessive strain and velocity. The valves of the air cylinder within the pump function routinely to actuate the cylinder. The pneumatic cylinder then strikes the plunger up and down to complete the pumping cycle.
Pneumatic grout pump may be pushed even with out Electrical power provide in remote areas by using engine driven compressor.
Applications
The pump is majorly used in building and mining industry for injecting material into wide and medium measurement gap in beams, columns ,basement walls and flooring, carry shaft concrete wall fill-up and so forth. In mining trade it is used to refill cement resolution where there’s a hole exists between construction and rock and for soil stabilization.
Detachable design tends to straightforward maintenance and transportation. Challenging works like Grouting in Bridges.
READ: How hydraulic submersible pumps work
This pump is extensively used in tunnels, coal mine, bridges and dams, constructing foundation, and other underground tasks, and inflammable, explosive websites and different dangerous surroundings.
It has utility in chemical trade also to pump out chemical slurries.
The pump is electricity free so, can be used at any web site condition whether it’s rural or city.
Mining Pneumatic Grouting pump has a larger discharge slurry adjustment vary. Generally ร้านซ่อมเครื่องวัดความดันโลหิต of the grouting quantity is 8 or10 times of the quantity to start with. And the final grouting amount proves that filling is compacted.
Simply put; Pneumatic high-pressure grouting pump is specifically designed for high-pressure grouting. And it adopts full hydraulic drive, it’s pressure and flow may be adjusted according to the requirements of grouting,(The move of grouting pump is 0-100L/min, stress of discharge is 0-10MPa).apart from, This Pneumatic high-pressure grouting pump can be used for grouting single or double fluid.
High-pressure grouting pump is principally used for highways, railways, water and electrical energy, building, mining etc. ground/underground construction.
Benefits
Mining Pneumatic Grouting pump has some great benefits of low power consumption, small vibration, low noise, small dimension, excessive effectivity, dependable efficiency, stress and flow management, lengthy life and so forth. Common mine grouting pump has pneumatic injection pump, dual fluid injection pump, extrusion injection pump and piston injection pump.
Pneumatic grout pump can also be Light weight and with a wheelie design it can be carried simply. It is designed for straightforward operation and low upkeep. Last but not least its spare components are simply obtainable.
Share